What we do...

At Flowcrete we will tailor our services to meet your requirements.
The supply only of materials or the supply and installation or the design, supply and installation with detailed drawings submitted to local boards.

We cover your entire Project! Architectural drawings, submissions to local authorities, engineering details & then we build from foundations to finishes.

Advantages...

This is a light floor, quick and easy to erect. Stripping time is also reduced to a minimum. Where long spans are required a saving is accured by the elimination of reinforced concrete beams that would be necessary with nornmal insitu construction.

Light load slab so foundations do not have to be underpinned
Quick & Easy to install
Cost Effective

The polystyrene blocks are suspended on pre-stressed beams. Then a high tensile mesh is laid down on which electrical conduct can be laid on and tied to. A 55mm or 65mm layer of 25mpa concrete is then cast.The polystyrene blocks are suspended on pre-stressed beams. Then a high tensile mesh is laid down on which electrical conduct can be laid on and tied to. A 55mm or 65mm layer of 25mpa concrete is then cast.

The amount of insitu concrete required is substantially reduced, resulting in savings in material and placing time.

Technical Data

Slab Type A Ultimate
Rmu
Dead per
Rib
Load per
m2
1 x 100 170mm Thick slab 14.973 1.5721 3.144226
2 x 100 170mm Thick slab
28.168
1.9801
3.300188
3 x 100 170mm Thick slab
40.346
2.3881
3.411590
4 x 100 170mm Thick slab
51.889
2.7961
3.495141


Slab Type B
Ultimate
Rmu
Dead per
Rib
Load per
m2
1 x 100 255mm Thick slab
24.735
1.7265
3.452904
2 x 100 255mm Thick slab
47.691
2.3385
3.897420
3 x 100 255mm Thick slab 69.630 2.9505
4.214931
4 x 100 255mm Thick slab 90.935 3.5625
4.453065

Here we are able to change
direction of our beams by
using hangers.
Here we achieved a 9m clear
span with a 1.5m cantilever by
using triple beams with a
200mm block and 100mm
concrete topping.

This picture shows a beam that
has been boxed with the
Flowcrete beams entering it
with exposed wires.

 

 
Flowcrete | 17 Martin Drive | Queensmead | 4093 | 031-463 1045 tel & fax | office@flowcrete.co.za
All right reserved. Copyright Flowcrete on all material.